Pathway Pathport Manager 5 User Guide Manuel d'utilisateur télécharger pdf (Page 29)

Pathway Connectivity

Pathport Manager 5 v1 Manual

Display Node Communications

Before choosing ‘Display Node Communications’ either from the TestTools menu or the

Nodes menu, a node must be selected in the Device List.

Non-DMX traffic between PM5 and the chosen node will be shown. When there are no

problems, about every six seconds PM5 will receive an ARP from the node. PM5 will

then send a ‘Get Properties” request, which the node will answer.

If there are communication problems between PM5 and the node, they will be reported

here, in various ways, dependent on what the problem is.

1 2 ... 24 25 26 27 28 29 30 31 32 33

Pas de commentaire

Pathway Pathport Manager 5 User Guide Manuel d'utilisateur Page 29